This part of IS0 2768 is intended to simplify drawing indications and specifies general geometrical tolerances to control those features on the drawing which have no respective individual indication. Part 2: Geometrical tolerances tolerance indications The use of general tolerances for size and geometry simplifies the task of ensuring that this prerequisite is met. nothing shall be implied or left to judgement in the workshop or in the inspection department. The tolerancing on the drawing should be complete to ensure that the elements of size and geometry of all features are controlled, i.e. For the deviation of size and for the deviations of the geometrical characteristics (form, orientation and location) the function of the part requires limitations which, when exceeded, impair this function. Introduction All features on component parts always have a size and a geometrical shape. International Organization for Standardization Case postale 56 l CH-1211 Geneve 20 l Switzerland Printed in Switzerland No part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. Parts, under the general title Genera/ tolerances: linearДЄnnexes A and B of this part of IS0 2768 are for informationДЄll rights reserved. They are approved in accordance with IS0 procedures requiring at least 75 % approval by the member bodies voting. Draft International Standards adopted by the technical committees are circulated to the member bodies for approval before their acceptance as International Standards by the IS0 Council. IS0 collaborates closely with the International Electrotechnical Commission (IECI on all matters of electrotechnical standardization. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. The work of preparing International Standards is normally carried out through IS0 technical committees.

``,`,```,``,`,```,``,`,```-`-`,`,`,`,`-Д¬OPYRIGHT 2003 International Organization for StandardizationДocument provided by IHS Licensee=Deere & Co/9999663100, User=, 00:03:32 MST Questions or comments about this message: please call the Document Policy Management Group at 1-80.ДЇoreword IS0 (the International Organization for Standardization) is a worldwide federation of national standards bodies (IS0 member bodies). Part 2: Geometrical tolerances tolerance indications Tolkrances

Iso 5459 free pdf